LJ9DA41 (12V)
Linear Actuator
- – All-In-One Design: drive train mechanics, electric motor, and advanced control board
- – Gears: 1st and 3rd gear made of metal, 2nd gear made of synthetic resin
- – Linear Motion Mechanism: Ball Screw
- – Water/Dust Resistance: IP64 level
- – Dimensions: 197.6 x 51.1 x 99.3 mm (7.78 x 2.01 x 3.91 in)
- – Weight: 720 g (25.4 oz)
- – Max Thrust @ 11.1 V: 36.7 kgf*cm (360 N or 1295 oz*in)
- – Rated Thrust @ 11.1 V: 7.3 kgf*cm (72.0 N or 259 oz*in)
- – Speed @ 11.1 V: 75 mm/sec or 3.0 in/sec (no load)
- – Voltage Range: 9.0 – 16.8V
- – Stroke: 50 mm (1.97 in)
AJ9DA/LJ9DA series are compatible with the following signal types:
– PWM: Conventional signal for servo of radio control use (ex. Pulse width of 1,520μS = center).
– S.Bus/S.Bus2: Futaba’s original serial signal format.
– RS485: Same as Futaba’s bi-directional protocol for “Command type servo for robot.”
– Do not use each protocol at the same time or the unit will get fatal damage.
– Analog DC output for monitoring the rod shaft position. The position can be monitored while powering up.